# Question: What Is The Pressure Of Co2 In A Paintball Cylinder?

## How many PSI is a 20 oz paintball tank?

A 20 – ounce CO2 paintball cylinder with a full charge (68% of its water capacity) When a fully charged, 68% full by water capacity, 20 – ounce CO2 cylinder warms up to room temperature (70 oF), the pressure inside the cylinder is 837 psi.

## Can you fill a paintball CO2 tank with compressed air?

CO2 tanks have valves that accommodate liquid fills. Compressed air is not a liquid, hence the fill nipple on high pressure air tanks. You cannot fill a CO2 tank with compressed air.

## What psi do paintball guns use?

High-pressure air, compressed air or nitrogen, is stored in the tank at a very high pressure, typically 21,000–31,000 kPa ( 3,000–4,500 psi ). Output is controlled with an attached regulator, regulating the pressure between 1,700 kPa ( 250 psi ) and 5,900 kPa ( 860 psi ), depending on the type of tank.

You might be interested:  FAQ: How To Fill A Paintball Air Tank At Home?

## Can you leave CO2 tank paintball gun?

If you leave the CO2 tank on your gun, then it is likely going to cause you problems. You see, keeping the air in the tank is actually going to be bad for the gun overall. It can potentially cause the gun to spring a leak or otherwise become damaged.

## How many shots are in a 20 oz CO2 tank?

This chart shows an estimated amout of how many shots you will get from your CO2 or compressed air tank. These values generally represent a standard outdoor temperature of 20º C.

Size Shots
14-oz 700
16-oz 800
20-oz 1100
24-oz 1225

## How many shots can a 3000 psi tank shoot?

There is a quick rule that can tell you how many shots you can get from a tank, simply multiply the volume by 12 for 3000 PSI tanks or 17 for 4500 PSI tanks. For example a 48 CI / 3000 PSI (48/ 3000 ) would be 576 shots.

## Is compressed air better than CO2 for paintball?

Compressed air’s main advantage is consistency. The more consistent pressure results in much more consistent performance. Compressed air is marginally affected by temperature, unlike CO2, making it great for cold weather and electronic guns. Most paintball fields charge for all-day compressed air fills.

## Can you shoot a paintball gun without CO2?

Air, no contest. CO2, when pressurized, turns into a liquid and is very cold. when it is unpressurized, it expands and can blow out lines in your gun. due to the expansion of the CO2, it also mess with your individual shot velocity.

You might be interested:  Often asked: Como Jugar A Paintball?

## Can you fill a compressed air tank at a gas station?

For example, if you need compressed air in any remote location where there’s no electricity to run a compressor, you can fill up an air tank at home (or at a gas station or hardware store on your way out) and carry it into the field.

## How much psi should a paintball tank have?

Compressed air tanks are pressurized up to the tank’s rating of 3000 PSI or 4500 PSI (Pounds per Square Inch). The pressure is then regulated through the tank’s regulator down to a lower PSI (450-850) to fire the paintball.

## Can paintball tanks explode?

Yes, paintball tanks can explode. There have been a few reported cases of paintball tanks exploding and harming others near the explosion.

## How fast does a paintball gun shoot in mph?

The average paintball has a velocity of about 280 fps, or 190 mph, which is far slower than any regular gun.

## How many shots can you get out of a 12 gram CO2 tank?

A 12 – gram CO2 cartridge may only give you between 20-30 good shots before you must let it warm up a bit and then take other shots. Some CO2 air guns in the market can deliver more shots and probably take longer to cool down.

## Can I keep CO2 in my gun?

From an operational and longevity standpoint, it’s actually best to leave the CO2 cartridge in the replica gun. Keeping the cartridge in the gun keeps pressure on the seals, which helps keep them lubricated.

## How long can you leave a CO2 cartridge in an air gun?

Officially, you ‘re supposed to empty it completely once you ‘ve put it in the gun. I’ve had mixed results leaving CO2 powerlets in my 4.5mm airgun, sometimes they bleed dry in a week or so, sometimes I’ll pick it up in 5 months and it will still shoot, at least a few times.